Some people slap their gear on a heli & just go fly, others get everything tidy and some people go to a lot of trouble to get their installation very neat & tidy.
So show us your installation & give us a few words on the dramas you had & the tips & tricks to make things work easier.
I'll kick it off. Here's my Logo 600SX installation:
Plenty of room to put stuff compared to a 450!
![]()
To get the wiring in beside the servo some material needs to be removed. A set of 4mm bullets added between the BEC & the feed from the battery so the BEC can be removed separately. Earth from the boom goes into the loom & pops back out for the counterbearing mount.
![]()
No easy way to keep wiring tidy on the back unless you're prepared to cut servo leads etc, which I wasn't. Each cable termination is labelled so if/when I need to remove things I know where they go (they all look the same once they're covered.......).
![]()
Receiver tucked in under the back to keep it out of the way. Getting all of the wiring in once it's covered required some juggling, but it was worth it.
![]()
OK, someone else can show us their heli.
Build Info Show Us Your Wiring & Installation Pics
Discussion in 'The Chat Room' started by mr_squiggle, May 24, 2014.
Comments
Discussion in 'The Chat Room' started by mr_squiggle, May 24, 2014.